1/29/2024 0 Comments Softraid not mounting![]() Proof that /dev/nvme1n1p1 is mounted: ~]# cat /proc/mounts | grep /boot/efi If all three matches, this probably also means that the partition that's mounted is the second one, the first partition is not mounted but used as a boot partition by UEFI subsystem. Multiple UUID's: ~]# blkid | grep 999C-7B59 Multiple LABEL's: ~]# blkid | grep EFI_SYSPART System has multiple partitions with the same LABEL or UUID LABEL=EFI_SYSPART /boot/efi vfat defaults 0 1 File /etc/fstab contains /boot/efi partition which is mounted by LABEL or UUID, examples as follows: The server has soft-raid 1 with /boot/efi partition and UEFI subsystem is used for boot.Ģ. ![]() After the conversion to a Cloudlinux issue stays the same.ġ. We have found that's there's an issue on some Centos 7/8 installations with different hosting companies that prevents updating correct /boot/efi/EFI/centos/grub.cfg file and then boot into a newer kernel. If you are running DELL server, you probably have THIS issue. However, this final step would be of no good if a given physical drive has already been taken offline from the logical one, since there is no longer any way to mount it, or modify its content.Note. The final alternative would seem to be to try to fill all filesystems with files full of /dev/zero, which may or may not make the logical drives have the same content, and then trying to do the comparison of the data on the physical drives with sha1 as in the step above. This would make it possible to compare data block-by-block (for example, by mounting the filesystems in read-only mode, and doing a sha1 of each physical drive, after ignoring the initial offset that's used to store the softraid information (unless it's stored in multiple locations on disc, like the filesystems do with some most important data)). There doesn't seem to be any code to this effect currently.Īnother alternative would be to completely zero-out all the physical drives prior to creating the softraid, or zero out out all the logical RAID volumes prior to creating the filesystems. However, since each filesystem on top of softraid is RAID-agnostic, there would have to be a special way to, perhaps, mount the filesystem in a read-only mode onto several different mounting points, with each mount being tied to a separate physical drive in the underlying RAID1, and then run a comparison tool to compare filesystem content between the drives. ![]() Is no point in wasting a lot of time syncing random data.Īs such, the integrity and consistency between the physical drives would have to be verified with the help of a filesystem. Is by design because all sectors that are read are written first. As the documentation for OpenBSD's softraid seems to indicate, the arrays are created without any kind of synchronisation taking place during the creation step: The RAID 1 discipline does not initialize the mirror upon creation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |